RESISTANCE WELDING CONTROLLER

FEATURES

• Suitable for single phase AC spot/projection welder and seam welder.
• CPU carries out the Feedback control during welding. It ensures the stable welding current even the fluctuation of power supply there. Guaranteed the welding quality.
• It has CC and CV function.
• Both single spot weld and continuous spot weld is available.
• pulses welding control function.
• Current upslope and downslope.
• Count the welding spots. Detect the actual voltage of the power supply. Detect the actual welding current (CC mode).
• Two type of current feedback: Welding transformer primary side and secondary side.
• Automatic self-diagnosis, display Error number for any abnormal condition.
• Maintain data from power. The data can be kept up to 10 years after power off.
• Power limit interface for convenient limiting the power capacity.

VIEW FULL CATALOGUE

SPECIFICATION

Mode Items			Resistance Welding Controller
			KCT01
Control factor / times		–	4/15 parameters / 3 times pulse control
Pressure valve drive		–	2 pressure valves, DC 24V
Feedback mode		–	Welding transformer primary side / secondary side
Rated input voltage		V	415V / 1 phase, ±10%
Frequency		Hz	50/60
Control parameter range	Pressure	–	Pressure valve 1
	parameter	–	1 – 15
	Initial pressure delay	cycle	0 – 199
	Initial pressure time	cycle	1 – 199
	Current upslope time	cycle	1 – 199
	Pre-heat time	cycle	0 – 199
	Pre-heat current	X 100A	20 – 199
	First cooling time	cycle	0 – 199
	Welding time	cycle	0 – 199
	Welding current	X 100A	20 – 199
	Second cooling time	cycle	0 – 199
	Temper time	cycle	0 – 199
	Temper current	X 100A	20 – 199
	Current downslope time	cycle	0 – 199
	Hold time	cycle	1 – 199
	Off time	cycle	0 – 99
	Transformer turn ratio	M	1 – 99
	Number of welding circuit	–	1 – 4
	Over current limit	–	5 – 99%
	Under current limit	–	5 – 99%
	Adding weld control while under current limit	–	1 / 1 time adding weld allowed, 0 / No adding weld
Suitable welding power source		–	Thyristor
Start mode		–	Pulse, normal
Welding Mode		–	Spot / projection, Seam
Keep ending signal		–	Built-in
Power signal		–	Build-in
Power control signal		–	Build-in
Monitor function		–	Weld spot count, welding current, current ratio etc.
Count function		–	Count welding spots
Switch running mode		–	Welding/adjustment, discontinuous/continuous